Fitting & Side Airbags

IMPORTANT:

This seat cover suits Front Bucket-Type Seats.
Please read these instructions carefully before installation.
Install seat covers exactly as described in fitting instructions.
Incorrect installation may affect Side Seat Airbag operation resulting in injury or death.

NOTE:
For vehicles not equipped with Side Seat Airbags please fit the drivers side cover on the passenger side seat and vice versa. This allows for the side panel of the seat (door-side) to be protected.

Locate drivers & passengers side covers before fitting. Drivers side cover and Passenger side cover are different.

The open panel of the cover must be on the door side of the car where the side airbag is or would be for none airbag seats.

Fitting Instructions

1.	Determine the side of the cover by locating the care label on the inside of the seat base cover.
2.	Remove Headrest from the seat backrest (Figure 1). Figure 1.
3.	Turn The Wet Seat cover inside out.
4.	Feed neoprene rod flap in between seat backrest and base (Figure 2). Figure 2.
5.	Roll backrest part of The Wet Seat cover over seat back and align to seat contours (Figure 3). Figure 3.
6.	Repeat Step 5 for base part of The Wet Seat cover (Figure 4). Figure 4.
7.	Where possible, tuck base part of The Wet Seat in between seat base and plastic trimming (Figure 5). Figure 5.

HEADREST HOLES Note: As the location of the headrest prongs vary between vehicles, headrest holes are not pre-cut into the Wet Seat covers. Please follow the below steps carefully in inserting holes into Wet Seat cover. Please follow the below steps carefully when inserting holes into Wet Seat cover.
8a.	Using 1-Inch Hole Punch With the Wet Seat aligned to seat backrest, mark the location of the headrest prongs. Take the cover off the seat and place on a flat surface with the marked area facing up. Be careful not to have the seat cover folded over when using the punch. Using a 1 inch hole punch, punch holes in Wet Seat cover at the marked area. Once complete refit cover as noted in Steps 3-6. Once re-fitted, tuck the cut headrest holes under the plastic trimming (Figure 8). Figure 6.
8b.	Using Scissors With the Wet Seat aligned to seat backrest, use your index finger and thump to locate the head rest prong position. Pinch cover and snip cover across about the size of a 10 cent coin (Figure 7). Once complete on both sides, tuck the cut headrest holes under the plastic trimming (Figure 8). Figure 7. Figure 8.
9.	Feed the hook & loop ties from the side to the back and secure. Be careful not to use too much force when pulling as the thread may come loose between the ties and cover (Figure 9). Figure 9. Figure 10.
10.	Re-install the headrests (Figure 11). Figure 11.
11.	Repeat steps 1-10 for remaining side cover.

IMPORTANT: Once you have finished fitting the covers, please ensure that the airbag seam is not covered. Re-align seat cover if necessary. Due to the stretch in the rubber backing, the seat cover can be adjusted after fitment. Driver side seat and The Wet Seat cover is shown in Figure 12 indicating the SRS Side Seat Airbag seam. Figure 12.